|
<< Click to Display Table of Contents >> Config Card Creator |
  
|
|
<< Click to Display Table of Contents >> Config Card Creator |
|
Create configuration card(s) to easily update Spider RFID Readers with a specific configuration.
Note | You need a new (unused) DESFire card and the desired configuration file to start this process!
Warning! | Used DESFire cards cannot be used again in this process.
The configured card will be used to program Spider RFID Readers with the written configuration file by presenting the card to the Spider RFID Reader within a specific time from the boot moment (as specified in the Spider Setting Configuration Card Acceptance Time).
1.Either drag and drop the file into the drag-and-drop-area or click 'Browse' to browse for a valid configuration file.
2.Configuration file selected. Click on “Program” to continue.
3.Lay an empty DESFire card on the Spider RFID Reader.
|
|
|
|---|---|---|
Writing the card could not be done in time. Either no DESFire card can be found within a number of seconds or another problem has arisen preventing a configuration to be written on the card. |
The program attempted to write the card, but encountered an error. The card has been used earlier at which time the application section has already been written on the card. |
The program tried to write the card, but the card was removed or the process aborted by the user. |
If no error messages occur, you should see the message that the process has finished successfully.
|
|---|
Success! |
The configuration card can now be used to write it's configuration onto other Spider RFID Readers
