<< Click to Display Table of Contents >> Spider RFID Reader Tool   Introduction

The Spider RFID Reader Tool can configure the Spider RFID Reader, Red Spider RFID Reader, Red Spider HF RFID Reader, and the SCR708 in a number of ways. It can upload firmware or configuration files to the Spider RFID Reader and last but not least it can analyze cards, identifying the card type and data that is on the card. In this manual only the Spider will be mentioned to illustrate how the tool works for inepro readers.

 

You can tweak the Card Reader Output with the Output Configurator, set the persistent settings in the Spider RFID Reader at Spider Settings, create a Config Card to transfer a configuration to multiple Spider RFID Readers, build your own custom configuration with the Configuration Builder or use the Programmer to load a configuration and/or firmware on the attached Spider RFID Reader.

 

We hope you will enjoy using our Spider RFID Reader Tool, and success with any endeavors in which you are using it,

 

The inepro team